RF315/433MHz module. Hardware connection instruction Tasmota uses the rc-switch library to decode RF codes. The ESP32R4 controller TASMOTA firmware is already built with the RC-switch library. The ESP32R4 controller is already configured for use RF-Receiver. If you need to change and update the setting, follow to this instruction. Open TASMOTA web interface. Menu – Configuration – Configure Module. Setup…
RF315/433MHz module. Hardware connection instruction ESP32R4 control has an inner socket for connecting an RF315/433MHz receiver or transmitter. The module itself is not included, you can purchase it on the website or from any other seller. The module connector is standard, and it will not be difficult to install it. This allows you to receive…
ESP32R4 controller have connection socket for RF315/433MHz receiver/transmitter module. (6) RF-receiver header connected to GPIO27 (ESP32). Firmware: For firmware settings follow these instructions: ESPHome/HASS settings and RF communication Guide. RF315/RF433MHz KeyFob or Wall Switch. TASMOTA settings and RF communication Guide. RF315/RF433MHz KeyFob or Wall Switch.